Progress!

Today after adding a few more finishing touches to the work space (tunes, a trash can, cutting mat, a new caster to replace the broken one on my old computer chair, etc.), I got to shoot some paint. I have no idea what to use for ‘primer,’ so I found some interior acrylic ‘Feather Gray’ at the hardware store, thinned it out, and shot it through the El Cheapo Harbor Freight airbrush. Getting the right mix of ‘thin enough for the AB was a challenge, but I eventually got some “primer” laid down on the Mustang body parts. I have no idea if it’s even going to stay stuck, so I’ll let it sit for a few days before checking it out – it’s stuck to my fingers quite nicely, however. If it won’t stick, no worries – it’s water based, should come right off, and I can start again once I find some real primer for the airbrush. I also learned a few valuable lessons today, in the way of securing the work, setting the flow needle, and making sure the airbrush actually stays together while cleaning it. Good times!

I joined an airbrush forum and had a question about there being an adapter for Paasche airbrushes, since their hoses and fittings are different than the ‘standard.’ I took this pic to hopefully show the difference between the hoses and fittings.